1.轧制过程中，冷床作业人员严禁上冷床，不准在辊道、齿条上行走。
2.生产中出现乱床等事故，冷拉设备报价，必须等停轧以后进行处理清出。
3.冷床取样要使用专用工具进行取样。
4.作业中应注意观察周围的情况，无关人员严禁进入大冷床的**区域。
5.因乱床等事故造成的热废品，冷拉设备，当班必须清出，确保冷床周围的环境整洁。
1. in the process of rolling， cooling bed workers strictly on bed， don"t walk on the roller rack.
2. in the production of random beds， such as accidents， must wait after the stop rolling process to clear out.
3. bed to use a special tool for sampling sampling.
Should observe the situation around 4. operati，冷拉设备生产， unrelated pers non dangerous region in the cold bed.
Waste heat 5. bed because of chaos caused by the accident， the duty must be clear， to ensure the surrounding environment clean bed。
轧件在冷床冷却过程中由于冷却水不能均匀分布在型钢表面，头部冷却速度较快，弯曲，形成浴盆状，使腹板上的积水不能流出，导致上表面收缩率明显大于型钢下表面，产生上弯。
为消除不均匀变形，首先应该使2辊压下量足够大，满足型钢塑变要求。消除型钢原有变形，达到统一的变形的目的。
Rolling in bed cooling process due to the cooling water can not be uniformly distributed on the surface of steel， the head of the fast cooling rate， the first bend forming tub shaped， make web water can not flow， resulting in the surface shrinkage rate was significantly higher than that of the steel surface， due to bending.
In order to eliminate the uneven deformation， first of all， the 2 roller should be large enough to meet the requirement of the type of steel plastic change. The original deformation of the steel has reached the goal of uniform deformation.
冷床主要有拔齿式冷床、齿条步进式冷床、拨爪式冷床、运载链式冷床、滚盘式冷床等。
将已轧制成型产品通过辊道输送进入冷床，再由齿条步进式拔齿等形式，将排列在冷床上的工件逐步移向冷床顶端，达到了工件的冷却效果。
The main bed tooth pulling type cooling bed，冷拉， rack step type cooling bed， poking claw type cooling bed， carrier chain cooling bed， rolling disc cooling bed etc..
The rolling molding products through the conveyor into the rack cooling bed， stepping teeth and other forms， will be arranged in workpiece cooling bed is gradually moved to the top of the bed， the cooling effect of the workpiece.
冷拉设备-冷拉-圣霖国际【顾客至上】由鞍山市圣霖进出口贸易有限公司提供。冷拉设备-冷拉-圣霖国际【顾客至上】是鞍山市圣霖进出口贸易有限公司升级推出的，以上图片和信息仅供参考，如了解详情,请您拨打本页面或图片上的联系电话，业务联系人：王秋。