ALPHA阿尔法RF800NS剂阿尔法助焊剂RF800NS

汉泰电子辅料有限公司是大陆地区***早从事***T工艺研究与制作的贸易商之一。公司具有多年电子行业从业经验，拥有一支高素质的***技术团队，专注服务于***T和PCB工艺制造焊接材料领域，主营阿尔法助焊剂、阿尔法锡膏、千住锡膏、阿米特锡膏、减摩锡膏、KOKI锡膏、铟泰锡膏、田村锡膏、***T贴片红胶、富士红胶、乐泰胶水、锡丝、锡条等***T焊接材料，欢迎来电咨询洽谈，我们将竭诚为您服务。

更多产品信息请登录http://

Alpha Metals RF800T 免洗助焊剂

No-Clean Flux

 

 FEATURES     BENEFITS

 

• Medium Solids Content • Pin Testable

• Non Corrosive Residues • High Sir Assemblies

 

DESCRIPTION

 

Alpha RF 800T is a low solids, no-clean flux formulated with a ***all percentage of rosin and non-halide activators. This unique rosin activation system promotes excellent wetting to protected copper and solder coated surfaces. Post soldering residue of Alpha RF 800T is minimal, slightly glossy and can be pin tested without removal.

 

USE

 

Alpha RF 800T flux is formulated to be applied with foam, w***e, spray and mist fluxers. Flux deposition, density and uniformity are critical to successful use of low solids no-clean flux. Applying RF 800T to a dry flux coating density of 100 to 300 micrograms per square centimetre is recommended. Preheating the circuit assembly will partially dry the flux, enhance oxide removal and promote optimum wicking, as well as superior solder joint formation. Degree of preheat is dependent on many variables; such as conveyor speed, type of components and

substrates. Entering the solder w***e with a top-side temperature of 90°C to 110°C and a bottom-side temperature of 120°C to 155°C is typical.

 

The foam applicators should be supplied with compressed air, free of oil and water. Maintain flux fluid level sufficiently above the aerator to produce adequate foam height. Adjust air pressure to produce optimum height with foam c***isting of uniform bubbles. The addition of flux thinners will be required to replace evaporative losses and maintain the balance in flux composition. Due to the low solids content of Alpha RF 800T flux, specific gr***ity is not an accurate measure for asses***ent. Monitoring and controlling the acid number is recommended for maintaining the flux composition. The acid number should be controlled between 21 and 22. 

In time, debris and contaminants will accumulate in recirculating type flux applicators. For c***istent soldering performance, dispose of spent flux in accordance with local bylaws, rules and regulati*** periodically. After emptying used flux, the reservoir and applicator should be thoroughly cleaned with flux thinner. Refill reservoir with fresh flux and allow a few minutes to stabilise before resuming soldering operation. In this type of flux application equipment, replace flux every 3 days where used daily for eight hours or more.

 

Although Alpha RF 800T is designed to be left on the board, if desired, post soldering residues can be removed with Alpha 2110 saponifier, Hydrex DX detergent or alternatively a semi-aqueous process using Alpha Auto Clean 40 may be employed.

 

Key factors for no-clean soldering: Start with clean boa*** and components. Maintain uniform flux coating. Separate boa*** to prevent flux carry-over.