插入适配器：打开48引脚双列直插式插座的触点并插入适配器，以便其后端与插座的后端对齐，引脚1（在图像或适配器本身标记）在前面。密切的接触，从而锁定到位适配器。
插入设备：向下推ZIF插槽的顶端，直到触点打开。如果可能的话，使用真空选取工具向插座中插入该设备。如果没有特别指明，引脚1位于插座的前沿。释放插座的顶端。如果您使用了引脚较少的设备转换器，放置设备朝向插座（距引脚1）的后边缘。

设备编程：编程前，目视检查设备的方向和设备与插座之间的连接。一般情况下编程器可以检测到不正确插入或引脚悬空，但可能会导致读取错误，甚至损坏设备。不要直接接触设备或插座的针脚。
删除设备：要取出设备，向下推ZIF插座转换器的顶部，直到触点打开的，挑选并使用工具删除设备。

Inserting an adapter: Open the contacts of the 48-pin DIL socket and insert the adapter so that its back end aligns with the back end of the socket, and Pin 1 (marked in the image or on the adapter itself) is at the front. Close the contacts, thus locking the adapter in place.

Inserting the device: Push the top of the ZIF socket downwa*** until the contacts open. If possible, use a vacuum pick tool for inserting the device into the socket. If not otherwise mentioned, Pin 1 is located at the front edge of the socket. Release the top of the socket. If you use the converter for devices with less pins, place the device towa*** the back edge of the socket (away from Pin 1).

Programming the device: Before programming, visually check the device orientation and the connection of device and socket. Incorrect insertion or unconnected pins are normally detected by the programmer, but can lead to read errors or even damage the device. Do not directly touch the pins of the device or the socket.

Removing the device: To take out the device, push the top of converter ZIF socket downwa*** until the contacts open, and use the pick tool for removing the device.